Bruker QUANTAX EDS User Manual

4.5 Configurator Bar QUANTAX EDS
33
Fig. 4.5-6 Standards configurator
activated. The configurator displays the following
information about the system and the standards
library:
 Number of standards in the standards library
 Calibration date (of the system factor)
 Calibration time (of the system factor)
 HV
 Geometry
Standards library. When clicking on the icon in
the bottom left corner of the Standards configurator
,
the ADMINISTRATION OF STANDARD LIBRARY
dialog pops up. For further details see section 5.12.4.
System calibration. When clicking on the icon in
the bottom left of the Standards config
urator, the
SYSTEM FACTOR CALIBRATION
dialog pops up.
For further details refer to section 5.10.
4.5.3
Microscope
Configuration
Fig. 4.5-7 Microscope configurator
Fig.
4.5-8 Microscope configurator select entry
menu
The Microscope configurator displays the
main
parameters of the electron microscope.
 Magnification: Image magnification set on the electron
microscope.
 High voltage: Acceleration voltage set on the electron
microscope.
 WD (working distance): Sample – pole piece distance
[mm].
 Stage X, Y, Z: Microscope stage position coordinates are
displayed, if available
The parameter to be displayed can be set by the user
by clicking with the right mouse key on the displayed
value in the configurator and selecting the desired
parameter in the Select entry menu.
When clicking on the icon in the bottom le
ft
corner of the Microscope configurator,
the
MICROSCOPE CONFIGURATION
dialog pops up. If
the data communication between microscope and
ESPRIT is active, the microscope parameters
Magnification, High voltage and Working distance
will be transferred from th
e microscope to ESPRIT
and displayed in this dialog.
Communication active. This option should be

Bruker QUANTAX EDS Specifications

General

Brand	Bruker
Model	QUANTAX EDS
Category	Laboratory Equipment
Language	English