2
Description
18/108 CLS Pro 600 – Line and Contrast Sensor
■ Connection lines between the individual system components
must be laid so that nobody can trip over them, not pulled tight
and well anchored down.
■ Ensure that there is sufficient free headroom. If the free pas-
sage is restricted, the relevant building components causing
the restrictions must be padded and a danger warning signs
must be affixed to them (yellow / black).
■ In principle, if the cable connections are (e.g. between the
sensor and sensors) disengaged then the sensor is no longer
connected to the power supply. Any infringements will result in
the warranty claim being invalidated.
■ The sensor has not been ATEX certified, i.e. it is not approved
for use in potentially explosive areas and must never be used in
them!
■ Any transport safety devices that were attached to the guiding
device must be removed prior to commissioning.
NOTICE
Please note:
Only trained specialist personnel are permitted to undertake the
assembly, installation and commissioning!
DANGER
Danger of cuts!
Never touch the edges of running material webs.
DANGER
Danger of crushing!
Never reach into the area in between the fixed lower frame and
the guiding device’s moving upper frame (rotating frame or swivel-
ling roller guide). Never reach into the area in between moving
rollers!
DANGER
Caution!
Ensure the equipment is electrically isolated before starting work.
To this end always carry out the following activities:
►
Switch off.
►
Prevent the device from being restarted.
►
Determine that the unit is ‘voltage-free’
►
Earth the unit.
►
Cover or fence off any adjacent parts that are still live.
ð Only then can the relevant work be undertaken!
WARNING
Caution!
Do not use the chassis or machine frame as a climbing aid or a ste-
pladder. Do not remove any of the safety devices.