83
MicroDock II
Troubleshooting
Problem Possible Cause Solution
The charger LED does not light when the
detector or battery pack is inserted (for
GasAlertMicro, GasAlertMicro 5/PID/IR,
GasAlertMicroClip and GasAlertQuattro
docking modules).
Charging the battery pack separately from
the detector is only applicable to
GasAlertMicro 5/PID/IR and GasAlertQuat-
tro
Detector or battery pack is not inserted into
the detector bay correctly.
Firmly insert the detector into the detector
docking bay.
The battery pack is above or below the
operating temperature 50°F–95°F
(10°C–35°C).
Allow the battery pack time to adjust to the
specified operating temperature (approxi-
mately 60 minutes).
The battery pack is severely depleted. Allow the detector to charge (2–4 hours).
The charger LED on the GasAlertMax XT
docking module lights solid for 15 minutes
and then deactivates. This behavior may
also occur while waiting in queue to charge.
Detector or battery pack is not inserted into
the detector bay correctly.
Firmly insert the detector or battery pack
into the detector docking bay.
The battery pack is severely depleted
Remove and insert the detector or battery
pack several times to restore charge capa-
bility.
To Next Page
Loading...
