Canon imagePROGRAF iPF8400S - Configuring Binding (Excel)

11 Enter Copies.
Note
• When Print in Draft mode is selected, printing is fast but the print quality is poor.
• When Saturation is selected, you can print posters, etc., vividly.
• Press the Print Preview button to display the preview screen. You can check and make changes to the layout in the
preview screen.
•
When you print to the edge of the roll width, the maximum print length is 18.0m.
12 If the upper and lower margins are too wide, check No Spaces at Top or Bottom (Conserve Paper).
The upper and lower margins can be checked in Print Preview.
13 Press Print to start printing.
Important
• If divided into plural pages, try reducing the data size or the range you select.
• You cannot run Print or Print Preview if you select it for a worksheet with no data displayed.
Configuring Binding (Excel)
Configuring Binding (Excel)
You can configure Binding margins for binding printouts.
1 Configure the settings up to Layout Selection in the Layout screen in Print Entire Sheet or Print Selected
Area.
Refer to "Print Entire Sheet(Excel)" ➔ P.337 and "Print Selected Area(Excel)" ➔ P.339 for the configuration
methods.
2 Click the Binding Settings button.
Important
• You cannot click the Binding Settings button in the following situations.
• When the Image Size is set to 100%
• When a graph is selected
• When page breaks have been set
• When a sheet or cell is protected
Open the Binding Settings dialog box.
3 If the Binding checkbox is not checked, select it to turn binding on.
4 Select Binding Edge.
5 Select Binding Margin.
Configuring Binding (Excel) iPF8400S
User's Guide
Windows Software Print Plug-In for Office
342