•
The Power Lamp and Message Lamp are not lit (even once), and nothing appears on the Display
Screen
Make sure the printer is plugged in correctly. Check the connection at the plug and electrical outlet.
•
No paper is loaded
Load paper. (See "Loading and Printing on Rolls.")
➔P.22 (See "Loading and Printing on
Sheets.") ➔ P.25
Important
• Starting the printer when it is connected via the USB cable to a Macintosh computer that is off may cause the computer to
start up at the same time. To prevent this, disconnect the USB cable before starting the printer. Connecting the printer to the
computer via a USB hub may solve this issue.
Turning the printer off
Important
• Never disconnect the printer's power supply or unplug it during a print job. This may damage the printer.
1
Make sure no print jobs are in progress.
If the Message Lamp is flashing, check the message on the
Display Screen and take action as necessary. (See "Error
Messages.") ➔ P.954
If the Data Lamp is flashing, the printer is receiving a print
job. Turn off the printer only after printing is finished.
2
Hold down the Power button for more than a second.
After "Shut Down.. Please Wait.." is shown on the Display
Screen, the printer shuts off.
Loading and Printing on Rolls
Loading and Printing on Rolls
These are the basic steps for loading and printing on rolls.
Follow these steps to load and print on rolls.
•
For details on using the Output Stacker, see "Using the Output Stacker." ➔ P.542
•
For details on using the optional Media Take-up Unit, see "Media Take-up Unit." ➔ P.671
Important
• If you are not using the optional Media Take-up Unit when printing long documents such as banners, spread a clean
cloth or paper on the floor. Use the Output Stacker to prevent long printed documents from being soiled by the floor
after they are printed. (See "Using the Output Stacker.") ➔ P.542
Loading and Printing on Rolls
iPF8400S
User's Guide
Basic Printing Workflow Printing procedure
22
To Next Page
Loading...
