219
Contents
Preparation/
Setup
Print Using a
Computer
Appendix
IndexPrint/SaveInput/Edit
Names of
Components
Maintenance/
Printer Settings
Trouble-
shooting
Message Details/Solution
Ribbon cassette isn’t set. Load the ribbon cassette. Press the [Enter] key to resume
printing.
(P.18)
End of media.
Pull out print media
The print media ran out during printing. Pull out the print
media from the printer and press any key. Replace the print
media with a new one and press the [Enter] key to resume
printing from the interrupted page.
(P.21)
Replace print media. Load a new print media and press the [Enter] key to resume
printing.
(P.21)
End of ribbon.
Replace ribbon cassette.
Replace the ribbon cassette with a new one and press the
[Enter] key to resume printing from the interrupted page.
Start of media not detect.
Remove media between
print head and cutter.
Remove the print media and make sure that the print media
is not stuck between the print head and the cutter. For
information on removing print media from between the
print head and cutter, refer to
"If a Tube or Label Tape
Becomes Jammed (P.206)"
. After setting the print media
correctly, press the [Enter] key to resume printing.
Print head position can’t be
initialized.
Press any key. If the same message appears again, contact
your place of purchase.
Print head can’t be moved to
print position.
Cut position can’t be
initialized.
Size switch lever is not
positioned correctly.
Proceed?
The size of the print media set on the printing preference
display does not match the position of the size switch lever.
(P.22)
If you select "Yes," printing will start.
To reset the settings, select "No" and follow the instructions
on the screen to set the size switch lever to the correct
position. Press any key to start printing.
Data check.
Resetting completely
An error has occurred in the data and all settings have
reverted to the settings at the time of purchase. All saved
les have also been deleted.
To Next Page
Loading...
