Group of settings Available settings Short description
[System settings] • [Date and time]
• [System of meas-
urement]
• [Time zone]
• [Update finisher
configuration]
• [Bulk tray 1 media
size]
• [Bulk tray 2 media
size]
The [System settings] section contains settings
to change the date and time of the system, or
the system of measurement used. When you
change the system of measurement, all corre-
sponding values on the system will be
changed. For example, when you change [Met-
ric] into [Imperial], all values will be displayed
in inches.
Furthermore, when a new finisher was added
to your configuration, you can use the [Update
finisher configuration] function to tell the sys-
tem that your configuration was updated. Then
the finisher will be added to the output loca-
tions in the job parameters section, for exam-
ple.
From the [System settings] you can also indi-
cate the media in the bulk trays one and two.
NOTE
A5 and Statement are only valid if
the bulk tray for small format is in-
stalled and configured by the service
technician. If you select A5 or State-
ment and the bulk tray for small for-
mat is not installed, you are not able
to assign media to the bulk tray.
[10] Change settings via the control panel
Change a Number of Settings in the Settings Editor via the Control Panel
Chapter 4 - Adapt Printer Settings to Your Needs
39
Canon varioPRINT 135 Series
To Next Page
Loading...
