Canon varioPRINT 110 - Page 41

Procedure
NOTE
The key operator PIN or the system administrator password is required to make changes in this
section.
1.
On the control panel, touch [System] -> [Setup] -> [Local key operator settings] (under
[Advanced]).
2.
Touch the button of the group that contains the setting you want to change or view.
3.
Touch the required setting.
4.
Look up the required information or make the required changes.
5.
When you make a change, touch [OK] to confirm.
6.
Press [Close].
Change a Number of Settings in the Settings Editor via the Control Panel
40
Chapter 4 - Adapt Printer Settings to Your Needs
Canon varioPRINT 135 Series