Model 201 Installation & Technical
8400-M117-O1 Rev D
fast= (Fast Target)
This is the filling target that the 201 DFC is set to fill to in the fast
part of the cycle.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ and F1/ keys to enter a new setting
and then press the F3/ key to save it. Allowable values for Fast
Target are: 0 through scale capacity.
foUT= (Fast Output)
This is the output that is driven when fast filling is occurring. This
is a binary field to allow for driving of more than one output during
this stage of the filling cycle. For more information see the 11.2
Output Assigning section.
sLo= (Slow Target)
This is the filling target that the 201 DFC is set to fill to in the slow
part of the cycle.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ and F1/ keys to enter a new setting
and then press the F3/ key to save it. Allowable values for
Slow Target are: 0 through scale capacity.
SoUT= (Slow Output)
This is the output that is driven when slow filling is occurring.
This is a binary field to allow for driving of more than one output
during this stage of the filling cycle. For more information see the
11.2 Output Assigning section.
To Next Page
Loading...