Model 201 Installation & Technical
8400-M117-O1 Rev D
dYtr= (Dynamic Trim)
This setting controls whether the 201 DFC application will
dynamically adjust the DFC Trim value based on
overshoot/undershoot of each fill. This can be used to ‘learn’ the
proper trim value. Once a trim value has been ‘learned’, which
usually takes between 3 and 10 filling cycles, it is recommended
to turn off dynamic trim.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ and F1/ keys to enter a new setting
and then press the F3/ key to save it.
AUtod= (Auto Dump)
This setting controls whether the 201 DFC will automatically
discharge after filling or waits for input from the operator or other
controlling system.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
AUtoP= (Automatic Print)
The automatic print feature will cause an optional printer to
automatically record the total weight, time, and date of the fill at the
conclusion of the fill.
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
no (No Automatic Print after fill operation)
YES (Automatic Print after fill operation is Enabled)
To Next Page
Loading...