Model 201 Installation & Technical
8400-M117-O1 Rev D
Soc= (Enable Raw Socket Server)
Press the F3/ key to show the current setting. If the setting displayed is
acceptable, press the F3/ key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/ key to save
it. Allowable settings are:
Off (Raw Socket Server is Disabled)
ON (Raw Socket Server is Enabled)
IMPORTANT! If EIP (Ethernet/IP) or Modbus/TCP is enabled, the
Raw Socket Server (SOC) should be disabled (set to oFF).
NOTE: If Soc= (Raw Socket Server) is Enabled (on), the following prompts,
Port= (Raw Socket Server Port), (Weight Mode) and prnt= (Print from
Port) will be displayed.
Port= (Raw Socket Server Port)
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the F2/
and F1/ keys to enter a new setting and then press the F3/ key to
save it. Allowable values for the raw socket server port are: 0 through
65000.
(Weight Mode)
Press the F3/ key to show the current setting. If the setting displayed is
acceptable, press the F3/ key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/ key to save
it. Allowable settings are:
Off (Weight mode is disabled)
To Next Page
Loading...
Need help?
General