Model 201 Installation & Technical
8400-M117-O1 Rev D
Http= (Enable Web Server)
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
Off (Web Server is Disabled)
ON (Web Server is Enabled)
NOTE: If HttP (Web Server) is Enabled (on), the
following prompts, Port and Limit Access will be active.
Port= (Web Server Port)
Press the F3/ key to show the current setting. To accept the
setting displayed, press the F3/ key again to save it. Otherwise,
use the F2/ and F1/ keys to enter a new setting and then press
the F3/ key to save it. Allowable values for the web server port
are: 0 through 65000.
(Limit Access by Client IP Range)
Press the F3/ key to show the current setting. If the setting
displayed is acceptable, press the F3/ key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/ key to save it. Allowable settings are:
To Next Page
Loading...
Need help?
General