Cardinal 201 - Page 84

Model 201 Installation & Technical
8400-M117-O1 Rev D
Page 76
D1b= (Maximum Weight – 20 mA)
This is the value, in weight, which outputs the maximum current
20 mA. All weights above this value will output maximum current
from the DAC.
Press the F3/  key to show the current setting. To accept the
setting displayed, press the F3/  key again to save it.
Otherwise, use the F2/ and F1/ keys to enter a new setting
and then press the F3/  key to save it.
This weight must be a positive value, up to capacity of scale, and
above the d1a= value. Allowable values: 0 through 999999.
dAC2= (Analog Output 2, Voltage)
Press the F3/  key to show the current setting. If the setting
displayed is acceptable, press the F3/  key again to save it.
Otherwise, use the F2/ key to toggle to a new setting and then
press the F3/  key to save it. Allowable settings are:
off
Off (Analog Output 2 is disabled)
gross
Track Gross Weight
net
Track Net Weight
0 u
0 volt output
1 u
1 volt output
2 u
2 volt output
3 u
3 volt output
4 u
4 volt output
5 u
5 volt output
6 u
6 volt output
7 u
7 volt output
8 u
8 volt output
9 u
9 volt output
10 u
10 volt output