Model 201 Installation & Technical
8400-M117-O1 Rev D
D2A= (Minimum Weight – 0 volts)
This is the value, in weight, which outputs 0 volts from the DAC. All
weight below this target will output 0 volts.
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the
F2/ and F1/ keys to enter a new setting and then press the F3/ key
to save it. Allowable values are: 0 through 999999.
NOTE: If a negative weight is required for the minimum weight,
you must use the Web Configuration Page.
D2b= (Maximum Weight – 10 volts)
This is the value, in weight, which outputs the maximum output 10 volts.
All weights above this value will output maximum volts from the DAC.
Press the F3/ key to show the current setting. To accept the setting
displayed, press the F3/ key again to save it. Otherwise, use the
F2/ and F1/ keys to enter a new setting and then press the F3/ key
to save it.
This weight must be a positive value, up to capacity of scale, and above
the d2a= value. Allowable values: 0 through 999999.
AdC= (Analog Input)
Press the F3/ key to show the current setting. If the setting displayed is
acceptable, press the F3/ key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/ key to save
it. Allowable settings are:
Off (Analog Input is disabled)
To Next Page
Loading...