Cardinal 825 - Page 102

8545-M838-O1 Rev D  825 Installation & Technical
96
CONFIGURATION, CONT.
Select TCP/IP Server
With the Select TCP/IP Server screen displayed, press the 1 key or use the Navigation Keys
to select (highlight) and then press the ENTER key to select Num 1. The display will
change to show the Setup TCP/IP Server 1 screen.
Setup TCP/IP Server 1
Enable:
With the Select TCP/IP Server 1 screen displayed, the current setting for the Enable:
parameter will be shown. If the setting displayed is acceptable, proceed to the next
parameter.
Otherwise, press the SPACE key to toggle its status. Select YES
*
to enable TCP/IP
Server 1 or NO to disable TCP/IP Server 1 and then press the  Down Arrow to advance
to the next parameter or press the ENTER key to save the new setting and return to the
previous screen.

If Yes is selected for Enable:, the following additional parameters will be shown
(below the Enable: parameter) and requires data to be entered. Otherwise, press the
ENTER key to return to the Select TCP/IP Server screen.
Port:
With the Select TCP/IP Server 1 screen displayed, the current setting for the Port:
parameter will be shown. If the setting displayed is acceptable, proceed to the next
parameter.
Otherwise, use the numeric keys to enter the TCP/IP port number and then press the 
Down Arrow to advance to the next parameter or press the ENTER key to save the new
setting and return to the previous screen.
Scale:
With the Select TCP/IP Server 1 screen displayed, the current setting for the Scale:
parameter will be shown. If the setting displayed is acceptable, proceed to the next
parameter.
Otherwise, use the numeric keys to enter the scale number for the server to use and then
press the  Down Arrow to advance to the next parameter or press the ENTER key to
save the new setting and return to the previous screen.