Cardinal 825 - Page 18

8545-M838-O1 Rev D  825 Installation & Technical
12
INSTALLATION, CONT.
6. Now, remove 1/4 inch of insulation from the end of each of the six wires (with sense leads)
or four wires (without sense leads).
7. Remove the screw securing the 825 Scale Input Board (825-SIB) to the main PC board and
then lift the 825-SIB straight up to remove it from the enclosure. See Figure No. 5.
8. Remove the 7-connector
terminal from the 825-SIB.
(Hold the board in place,
grasp the terminal block
connector, and lift straight
up away from the board).
See Figure No. 6.
6 inches
3/4 inch
1/4 inch
Figure No. 4
Remove
this screw
CAUTION!
Be careful not to strike board
against side of 825 enclosure
when removing.
Figure No. 5
Hold board.
Grasp here
and lift up.
Figure No. 6