8545-M838-O1 Rev D 825 Installation & Technical
KEYPAD FUNCTIONS, CONT.
Standard Indicator Keys, Cont.
NET/GROSS
Pressing the N key (if in Gross mode) or the G key (if in Net mode) will toggle between the
Gross weight and Net weight. In the Gross weight mode, the total of all weight placed on
the scale since the display was zeroed is displayed. In the Net Weight mode, the Gross,
Tare and Net weight is displayed.
NOTE: If a valid tare weight has not been entered, pressing this key will momentarily
display the message:
Cannot show net – tare zero
The display will return to the Weight screen, showing gross weight only
ID
This key allows the operator to enter an ID (identification) for use in printing. Note that after
entering an ID, it will be displayed on the Weight screen below the ID key.
1. Press the I key.
2. The display will change to show the Set ID screen.
3. Using the alphanumeric keys, enter up to a ten (10) character ID and then press the
ENTER key to save it.
NOTE: Once an ID has been entered, it will remain until another ID is entered or it is
cleared.
1. To clear an ID, first press the I key.
2. With the Set ID screen displayed, press the SPACE key and then the ENTER key.
3. The display will return to the Weight screen with no ID shown below the ID key.
ZERO
Pressing the Z key allows the operator to reset the Gross weight to zero. IMPORTANT! If
the gross weight exceeds the zero limit for this key, pressing this key will momentarily
display the message:
CANNOT ZERO –
The display will return to the Weight screen, showing gross weight only
Note that the zero limit may be either 4% or 100% of the scale capacity. This limit is set
during setup and calibration (see the Zero Limit parameter).
TARE (Pushbutton Tare)
Pressing the A key will act as a pushbutton tare and will store the current Gross weight as
the new tare weight and will switch the display to the Net weight mode.
To Next Page
Loading...
