8545-M838-O1 Rev D 825 Installation & Technical
SETUP AND CALIBRATION, CONT.
WARNING! The membrane keypad is not to be operated with pointed objects
(pencils, pens, fingernails, etc). In addition, the interactive touch screen is
glass and should not be operated with pointed objects and with excessive
force. Damage to the keypad and touch screen resulting from this practice is
NOT covered under warranty.
Figure No. 23
Use the Navigation Keys to select (highlight) the parameter to change or press the number
key corresponding to the parameter to change.
Press the Navigation Keys Down Arrow to “advance” to the next parameter selection.
Press the Navigation Keys UP Arrow to “backup” to the previous parameter selection.
Press the Navigation Keys Left Arrow to “exit” to the previous screen.
Pressing the alphanumeric or Navigation Keys ENTER key without entering a new value
will retain the current setting and return to the previous or next screen.
Use the alphanumeric keys to enter new values for parameters requiring data input.
Some parameters require pressing the SPACE key to toggle its status or to step through
the available selections.
After entering (or selecting) a new value, press the Navigation Keys Down Arrow to
advance to the next parameter or press the ENTER key to save the new setting and return
to the previous or next screen.
Press the ESC/ (backspace) key to delete an incorrect value or character entered.
CAL displayed
when Calibration
Inhibit jumper is
removed.
To Next Page
Loading...
