8545-M838-O1 Rev D 825 Installation & Technical
SETUP AND CALIBRATION, CONT.
DHCP:
With the Setup Network screen displayed the current setting for the DHCP: parameter will
be shown. If the setting displayed is acceptable, proceed to the next parameter.
Otherwise, press the SPACE key to toggle its status (select YES or NO) and then press
the Down Arrow to advance to the next parameter or press the ENTER key to save the
new setting and return to the previous screen.
Select Yes for automatic IP
assignment from a DHCP server
connected to your network
Selecting NO allows manual entry
of the Client IP, Gateway, Netmask,
Broadcast, and Nameserver values
NOTE: If No is selected for DHCP:, the following additional parameters will be
shown and require data to be entered. Otherwise, proceed to the Web
Server: parameter.
Client IP:
With No selected for DHCP: the current setting for Client IP: will be shown. If the
setting displayed is acceptable, proceed to the next parameter.
Otherwise, use the numeric keys (and the period key) to enter the IP address for this
indicator and then press the Down Arrow to advance to the next parameter or press
the ENTER key to save the new setting and return to the previous screen. The format for
the IP address is: ## . # . # . ## (e.g., 90.1.2.68). IMPORTANT! No other device on the
network should have this IP address.
Gateway:
With No selected for DHCP: the current setting for Gateway: will be shown. If the
setting displayed is acceptable, proceed to the next parameter.
Otherwise, use the numeric keys (and the period key) to enter the gateway address and
then press the Down Arrow to advance to the next parameter or press the ENTER key
to save the new setting and return to the previous screen. The format for the gateway
address is: # . # . # . # (e.g., 0.0.0.0).
Netmask:
With No selected for DHCP: the current setting for Netmask: will be shown. If the
setting displayed is acceptable, proceed to the next parameter.
Otherwise, use the numeric keys (and the period key) to enter the Netmask and then
press the Down Arrow to advance to the next parameter or press the ENTER key to
save the new setting and return to the previous screen. IMPORTANT! The Netmask of
the indicator should match the Netmask of the other computers on your network. The
format for the Netmask is: ### . ### . ### . # (e.g., 255.255.252.0).
To Next Page
Loading...
