8545-M838-O1 Rev D 825 Installation & Technical
SETUP AND CALIBRATION, CONT.
Broadcast:
With No selected for DHCP: the current setting for Broadcast: will be shown. If the
setting displayed is acceptable, proceed to the next parameter.
Otherwise, use the numeric keys (and the period key) to enter the broadcast address and
then press the Down Arrow to advance to the next parameter or press the ENTER key
to save the new setting and return to the previous screen. The format for the gateway
address is: ## . # . # . # (e.g., 90.1.2.3).
Nameserver:
With No selected for DHCP: the current setting for Nameserver: will be shown. If the
setting displayed is acceptable, proceed to the next parameter.
Otherwise, use the numeric keys (and period key) to enter the address of a name server
to translate names into IP addresses and then press the Down Arrow to advance to
the next parameter or press the ENTER key to save the new setting and return to the
previous screen. The format for the Nameserver is: ## . # . # . # (e.g., 90.1.2.8).
Web Server:
With the Setup Network screen displayed the current setting for the Web Server:
parameter will be shown. If the setting displayed is acceptable, proceed to the next
parameter.
Otherwise, press the SPACE key to toggle its status (select YES or NO) and then press
the Down Arrow to advance to the next parameter or press the ENTER key to save the
new setting and return to the previous screen.
Startup Web Server is Enabled.
Startup Web Server is Disabled.
Weight Server:
With the Setup Network screen displayed the current setting for the Weight Server:
parameter will be shown. If the setting displayed is acceptable, press the ENTER key or
the Navigation Keys Left Arrow to return to the previous screen.
Otherwise, press the SPACE key to toggle its status (select YES or NO) and then press
the ENTER key to save the new setting and return to the previous screen.
Startup Weight Server is Enabled.
Startup Weight Server is Disabled.
To Next Page
Loading...
