8545-M838-O1 Rev D 825 Installation & Technical
SETUP AND CALIBRATION, CONT.
Totalizer
Capacity:
With the Totalizer screen displayed the current setting for the Capacity: parameter will
be shown. If the setting displayed is acceptable, proceed to the next parameter.
Otherwise, use the numeric keys to enter the Totalizer capacity and then press the
Down Arrow to advance to the next parameter or press the ENTER key to save the new
setting and return to the Setup Scale Number screen. Note that the Capacity cannot
exceed 7 digits. Allowable values are 1 through 9,999,999.
With the Setup Scale Number screen displayed, use the numeric keys to enter the number
for the scale to calibrate or press the Down Arrow and then press the ENTER key to
select the scale to calibrate.
To Next Page
Loading...
