Chapter 8 – Appendix
Section 8.2 – Summary of Operator Steps
8-7
Repeat Set
Loading for
Container 2
Refer to Section 4.5 for details.
If two containers have been selected for treatment, the ‘Enter treatment
data for container 2’ screen will appear.
Follow previous steps to load the second set into the illuminator tray and
scan the barcodes, placing the second container in the rear chamber 2.
The ‘Close drawer and door’ screen will appear
Step Action
1. Make sure that all tubings are in the tray and the
containers are flat.
2. Close the tray cover and ensure that it is secured by the
black latch.
3. Push the drawer into the illuminator until it clicks in place.
4. Close the door.
5. The ‘Running’ screen will appear.
Illumination
Interruption
Refer to Section 4.7 for details.
Step Action
1. To stop treatment at any time, press the ‘Stop’ button. The
‘Are you sure you want to stop treatment?’ screen will
appear.
2. Press ‘No’ button to resume treatment, or press ‘Yes’
button to end treatment.
To Next Page
Loading...