Check Point HARMONY R81 - Page 38

Connection Port to Services on an Endpoint Security Management Server
R81 Harmony Endpoint Server Administration Guide|38
l
A Security Management Server listens to Endpoint Security SSL traffic on the
TCP port 443
l
A Security Management Server listens to SSL traffic for all other services on the
TCP port 4434:
Service URL and Port
Gaia Portal
https://<IP Address of Gaia
Management Interface>:4434
SmartView Web
Application
https://<IP Address of Management
Server>:4434/smartview/
Management API Web
Services
(see Check Point
Management API
Reference )
https://<IP Address of Management
Server>:4434/web_api/<command>
In R81 and higher, an administrator can manually configure different TCP ports for the
Gaia Portal (and other services) and Endpoint Security - 443 or 4434. For the
applicable procedures, see "Connection Port to Services on an Endpoint Security
Management Server" on page35 .
For the applicable procedures, see the R81 Harmony Endpoint Security Server
Administration Guide > Chapter Endpoint Security Architecture > Section Connection
Port to Services on an Endpoint Security Management Server .
In R81 and higher, an administrator can manually configure different TCP ports for the
Gaia Portal (and other services) and Endpoint Security - 443 or 4434. See the
applicable procedures below.
SSL connection ports on Security Management Servers R80.40 and lower
n
When you enable the Endpoint Policy Management Software Blade on a Security
Management Server, the SSL connection port to these services automatically
changes from the default TCP port 443 to the TCP port 4434: