CIM ME2000S - Page 125

9 - DIAGNOSTICS
DIAGNOSTICA (ME)
ME2000S - User Manual
125 - 133
CODE MESSAGE DESCRIPTION SOLUTION
58
Motor z (Zero: First zero active
not detected)
Error during the reset of the
Wheel axis
Check the “WHEEL-motor” sensor
and/or switch o󰀨 the machine and
check the motor movement. If the
error is still present, contact technical
support.
59
Motor z (Zero: Zero not active not
detected)
60
Motor z (Zero: Second zero active
not detected)
61
Motor z (Zero: First zero not active
not detected)
62
Motor z (Zero: Di󰀨erence in steps
is too high)
63 Motor z (Zero: Motor busy) Internal error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
64 Motor clamp (Generic)
Clamp motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
65 Motor clamp (Driver generic)
66 Motor clamp (Driver high Z)
67 Motor clamp (Driver busy)
68 Motor clamp (Driver direction)
69 Motor clamp (Driver status)
70 Motor clamp (Driver command)
71 Motor clamp (Driver step mode)
72
Motor clamp (Driver under-
voltage)