CIM ME2000S - Positioning the Machine

5 - INSTALLATION
INSTALLAZIONE (ME)
ME2000S - User Manual
42 - 133
5.1 Checking the accessories provided
WARNING
Before installing the machine, it is recommended that you make sure that the bag and the
accessories are intact.
Any damage during transport could a󰀨ect the overall performance.
The accessories supplied with the machine, in a separate bag, are listed below:
• 1 power cable with SCHUKO plug (CEE 7)
• 1 USB memory stick containing the user manual and “PowerTag” software
• 2 keys for opening the front panel of the machine
• 1 USB hardware key for using the “PowerTag” software
CAUTION
Do not carry out any work with the machine before having read the entire user manual carefully.
The code for the software kit (USB cable not included) is shown below:
P8315018 POWERTAG LITE 
1) N8415004 POWERTAG LITE HARDWARE KEY
2) C5513098 USB KEY
3) C5513099 BOX FOR 2GB USB KEY
WARNING AVERTISSEMENT
Do not perform any job before carefully reading
the whole operator’s manual.
N’exécutez aucun travail avant de lire
attentivement l’entier manuel d’utilisation.
WARNING AVERTISSEMENT
Use only power cables not longer than 4.6 m,
type SVT or SJT, 3x18 AWG 10 a, equipped with
ground cable.
Utilisez uniquement des câbles d’alimentation
de 4,6 m de longueur maximale, type SVT ou
SJT, 3x18 AWG 10 a, équipés d’un câble de terre.
WARNING AVERTISSEMENT
The embosser weighs about 30 kg. handle with
care and caution
La machine pese environ 30 kg. manipuler avec
soin et prudence.