CIM ME2000S - Disassembling and Disposal

9 - DIAGNOSTICS
DIAGNOSTICA (ME)
ME2000S - User Manual
126 - 133
CODE MESSAGE DESCRIPTION SOLUTION
73
Motor clamp (Driver under-voltage
ADC)
Clamp motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
74 Motor clamp (Driver over-current)
75 Motor clamp (Driver thermal)
76
Motor clamp (Zero: First zero
active not detected)
Error during the reset of the
Clamp motor
Check the “CLAMP-motor” sensor
and/or switch o󰀨 the machine and
check the motor movement. If the
error is still present, contact technical
support.
77
Motor clamp (Zero: Zero not active
not detected)
78
Motor clamp (Zero: Second zero
active not detected)
79
Motor clamp (Zero: First zero not
active not detected)
80
Motor clamp (Zero: Di󰀨erence in
steps is too high)
81 Motor clamp (Zero: Motor busy) Internal error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
82 Motor punch (Generic)
Punch motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
83 Motor punch (Driver generic)
84 Motor punch (Driver high Z)
85 Motor punch (Driver busy)
86 Motor punch (Driver direction)
87 Motor punch (Driver status)