CIM ME2000S - Page 124

9 - DIAGNOSTICS
DIAGNOSTICA (ME)
ME2000S - User Manual
124 - 133
CODE MESSAGE DESCRIPTION SOLUTION
43
Motor y (Zero: First zero not active
not detected)
Error during the reset of axis Y
Check the “Y-motor” sensor and/or
switch o󰀨 the machine and check the
motor movement. If the error is still
present, contact technical support.
44
Motor y (Zero: Di󰀨erence in steps
is too high)
45 Motor y (Zero: Motor busy) Internal error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
46 Motor z (Generic)
Wheel motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
47 Motor z (Driver generic)
48 Motor z (Driver high Z)
49 Motor z (Driver busy)
50 Motor z (Driver direction)
51 Motor z (Driver status)
52 Motor z (Driver command)
53 Motor z (Driver step mode)
54 Motor z (Driver under-voltage)
55
Motor z (Driver under-voltage
ADC)
56 Motor z (Driver over-current)
57 Motor z (Driver thermal)