CIM ME2000S - Page 128

9 - DIAGNOSTICS
DIAGNOSTICA (ME)
ME2000S - User Manual
128 - 133
CODE MESSAGE DESCRIPTION SOLUTION
103 Motor loader (Driver busy)
Loader motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
104 Motor loader (Driver direction)
105 Motor loader (Driver status)
106 Motor loader (Driver command)
107 Motor loader (Driver step mode)
108
Motor loader (Driver under-
voltage)
109
Motor loader (Driver under-
voltage ADC)
110 Motor loader (Driver over-current)
111 Motor loader (Driver thermal)
112
Motor loader (Zero: First zero
active not detected)
Error during the reset of the
Loader motor
Check the “LOADER-motor” sensor
and/or switch o󰀨 the machine and
check the motor movement. If the
error is still present, contact technical
support.
113
Motor loader (Zero: Zero not
active not detected)
114
Motor loader (Zero: Second zero
active not detected)
115
Motor loader (Zero: First zero not
active not detected)
116
Motor loader (Zero: Di󰀨erence in
steps is too high)
117 Motor loader (Zero: Motor busy) Internal error
Turn o󰀨 the machine and wait some
seconds. Check if any plate left is
jammed. Start and reset the machine.
If error persists contact Technical
Assistance.