CIM ME2000S - Page 132

10 - DISASSEMBLING AND DISPOSAL
SMALTIMENTO
ME2000S - User Manual
132 - 133
10.1 WEEE legislation (Waste Electrical and Electronic Equipment)
MF Group srl - CIM division declares that its products are compliant with Directive 2012/19/EU on waste electrical
and electronic equipment, the purpose of which is to prevent WEEE, and to promote reuse, recycling and other
forms of waste recovery.
MF Group srl - CIM division is registered, in accordance with the law, in the Italian WEEE Register, number A.E.E.
IT08020000003483 and fulls its obligation to nance the management of WEEE by participating in a collective
collection system.
CROSSED-OUT WHEELIE BIN
The crossed-out wheelie bin symbol on the product or its packaging indicates that it must not be
disposed of as household waste. It should be taken to an appropriate waste collection centre for
the recycling of electrical and electronic equipment.
10.2 Disassembling / disposal
Machine disassembling, including for the purpose of disposal, should be carried out by specialized personnel,
assisted by MF Group srl - CIM division technicians, if necessary.
Before disassembling the machine:
1) shut down the machine
2) disconnect the machine from external power sources
3) drain/discharge the various circuits.
In addition to the need for specic knowledge and equipment, certain procedures are required in order to disassemble
the machine and separate it into the various materials used.
It is therefore recommended that you contact the MF Group srl - CIM division technical support service to ensure
that the work is carried out safely.
WARNING
Make sure this product is disposed of correctly to avoid potential damage to the environment
and human health.
10.3 Disposing of components
The machine was built using non-hazardous materials, which therefore do not pose problems for disposal or recycling.
However, during disassembling, the various types of component have to be separated:
• electrical equipment (wiring etc.)
• plastic materials (guards etc.)
• ferrous metals etc.
so that they can be properly disposed of or recycled.
RESPECT THE ENVIRONMENT!
Dispose of waste carefully, do not burn plastic materials, dispose of components in compliance
with the environmental regulations in your country.