CIM ME2000S - Page 50

6 - USE AND OPERATION
Impostazioni iniziali (ME2000S)
ME2000S - User Manual
50 - 133
A
B
C
1
1
2
3
1 mm
0,039 inch
6.3 Loading hopper adjustment
The metal tag loading hopper is located on the right side of the machine and can be adjusted according to the size
of the tags.
To adjust the loading hopper, proceed as follows:
1) Loosen (A) the black knobs (1) on the right side of the loading hopper.
2) Move (B) the right support (2) towards the tag (3), leaving a tolerance of about 1 mm - 0.039 inches.
3) Tighten (C) the black knobs (1).