94
Enter Setup
2564 Barcode Scanner User Guide
2.7 USB VIRTUAL COM VIA BT CRADLE
Use the USB cable to connect the scanner via cradle to the USB port of PC and connect
the power supply cord. You may run HyperTerminal.exe on your computer, and the
scanned data will be transmitted to the computer.
Warning: When the cradle is solely on USB power, the current may be insufficient for
it to function normally. You must connect the power supply cord.
Note: If using USB Virtual COM for the first time, you must install its driver beforehand.
Driver version 5.4 or later is required. Please remove older versions!
2.7.1 ACTIVATE USB VIRTUAL COM
Activate Cradle
USB Virtual COM
2.7.2 ACTIVATE USB VIRTUAL COM_CDC
Activate BT Cradle
USB Virtual COM_CDC
2.7.3 INTER-FUNCTION DELAY
By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of millisecond, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
Inter-Function
Delay… (*0~254)
1) Read the barcode above to specify the inter-function delay.
2) Read the “Decimal Value” barcode on page 251 for the desired inter-function delay
(millisecond).
3) Read the “Validate” barcode on the same page to complete this setting.
To Next Page
Loading...
Need help?
General
