244
Enter Setup
2564 Barcode Scanner User Guide
BT CRADLE SERIAL COMMAND AND EQUIVALENT SETUP BARCODES
To configure the cradle.
Here is the setup barcode for this serial command:
A list of the current settings will be displayed. Run HyperTerminal.exe on your
computer and change the settings one by one.
To restore the default settings.
Here is the setup barcode for this serial command:
To allow only one scanner connecting to the cradle.
Here is the setup barcode for this serial command:
To allow up to seven scanners connecting to the cradle.
Here is the setup barcode for this serial command:
To use one Virtual COM port for all whenever connecting the cradle to PC via USB.
This setting requires you to connect one cradle at a time, and will facilitate
configuring a great amount of cradles via the same Virtual COM port (for
administrators’ or factory use).
Here is the setup barcode for this serial command:
To use variable Virtual COM port when connecting more than one cradle to PC via
To Next Page
Loading...
Need help?
General
