EasyManuals Logo

CipherLab 2564 User Manual

CipherLab 2564
291 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
21
Update
This chapter explains the features and usage of the barcode scanner.
IN THIS CHAPTER
1.1 Battery ...................................................................... 21
1.2 Memory ..................................................................... 26
1.3 LED Indicator ............................................................. 29
1.4 Beeper....................................................................... 31
1.5 Send “NR” to Host ....................................................... 35
1.6 Scan Modes ................................................................ 36
1.7 Scanning Timeout ....................................................... 40
1.8 Delay between Re-read ................................................ 41
1.9 Read Redundancy (1D) ................................................ 42
1.10 Addon Security for UPC/EAN Barcodes ......................... 43
1.11 Auto-Sense Mode ...................................................... 43
1.13 Picklist Mode ............................................................. 44
1.14 Mobile Phone/Display Mode ........................................ 45
1.15 Serial Number Stamp ................................................ 45
1.16 2D Decode Settings ................................................... 46
1.1 BATTERY
The scanner is powered by a rechargeable 3.7 V/800 mAh Li-ion battery, and it takes
approximately 5 hours to charge the battery to full (from the power adaptor). However,
the charging time may vary by working condition. For intensive data collection, you may
need a spare battery for uninterrupted operation.
Note: The scanner supports power economy. Refer to settings of “Power Economy”, “Sniff
Mode”, as well as “Low Battery Alarm”.
1.1.1 TURN ON-OFF THE SCANNER
Turn on the scanner
After installing the battery, pull down the trigger for about 2 seconds. The scanner will respond
with a long beep (high tone), then the LED will become solid red and go off quickly.
Turn off the scanner
Remove the battery directly or let it turn off automatically in specific circumstances.
Chapter 1
UNDERSTANDING THE BARCODE SCANNER

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CipherLab 2564 and is the answer not in the manual?

CipherLab 2564 Specifications

General IconGeneral
BrandCipherLab
Model2564
CategoryBarcode Reader
LanguageEnglish

Related product manuals