CipherLab 2564

239
Update
SERIAL COMMANDS
D
Purpose
To disable the scanner.
Remarks
“D”
E
Purpose
To enable the scanner.
Remarks
“E”
#@ nnnnnn <CR>
Purpose
To configure the scanner.
Remarks
nnnnnn – the six digits of command parameters.
For example, “109952” is to list the current Code ID settings.
“0x23” + “0x40” + “0x31” + “0x30” + “0x39” + “0x39” + “0x35” + “0x32” + “0x0d”
Note: After configuring the scanner, send the serial command “#@109999” to save the
settings.
#@ - - - -<CR>
Purpose
To halt the scanner.
Remarks
“0x23” + “0x40” + “0x2d” + “0x2d” + “0x2d” + “0x2d” + “0x0d”
#@ . . . . <CR>
Purpose
To resume operation.
Remarks
“0x23” + “0x40” + “0x2e” + “0x2e” + “0x2e” + “0x2e” + “0x0d”
#@////<CR>
Purpose
To respond with a beep.
Remarks
“0x23” + “0x40” + “0x2f” + “0x2f” + “0x2f” + “0x2f” + “0x0d”
Appendix II
HOST SERIAL COMMANDS
Serial Command
List Page 3