CipherLab 2564 User Manual

31
Update
Chapter 1 Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь отображаться.
1.4 BEEPER
The scanner has a buzzer to give feedback for various operating conditions.
Beeping
Meaning
One long beep, high tone
Power on, with red LED on (1 second) and off quickly
One short beep, high tone
 Programmable, default to 4 KHz
Good Read, with green LED on-off quickly
Six short beeps
 High-low tone repeats three
times
 Enter Configuration Mode, with red LED flashing
 Exit Configuration Mode
Two short beeps, low-high tone
Setup barcode read successfully
One short beep, high tone
 More setup barcode required
 Input PIN code
 Clear PIN code
One short beep, low tone
More barcodes required to complete the “output sequence”
requirements of Multi-Barcode Editor, with green LED on-off
quickly (Upon completion, same as Good Read.)
One long beep, low tone
 Transmit buffer full, with red LED on-off quickly
 Transmit buffer disabled, with red LED on-off quickly
 Configuration error (Wrong barcode…)
 PIN code input error
 Reject random PIN request
 Fail to send data in memory mode
Two short beeps, high-low tone
 Data saved to buffer when transmit buffer is enabled
and the scanner is out of range, with red LED on-off
quickly
 Memory Mode – Memory full, with red LED on-off quickly
Two short beeps, high tone
Low Battery Alarm
Two long beeps, high-low tone
Multi-Barcode Mode – Buffer full
Three short beeps, tone ascending
from low to high
 WPAN connection established, with blue LED flashing
 WPAN connection resumed, with blue LED flashing
Three short beeps, tone ascending
from high to low
WPAN connection out of range or suspended

CipherLab 2564 Specifications

General

Brand	CipherLab
Model	2564
Category	Barcode Reader
Language	English