56
Enter Setup
2564 Barcode Scanner User Guide
Note: If you select “Numeric Keypad”, the Num Lock status of the physical keyboard
should be “ON”. This setting is not supported on PDAs.
Kanji Transmission is supported by the scanner when either Bluetooth HID, Keyboard Wedge via
the cradle or USB HID via the cradle is selected for the output interface. By Kanji Transmission,
when the host computer is running on Japanese Windows O.S., the scanner is able to transmit
Japanese characters including the Chinese characters used in modern Japanese writing system.
Kanji Transmission is disabled by default. Enable/disable scanner’s Kanji Transmission by reading
the following barcodes:
2.1.4 INTER-CHARACTER DELAY
By default, the inter-character delay is set to zero. Specify a value, ranging from 0 to
254 in units of millisecond, to match the computer response time of the keyboard
interface. Such delay time is inserted between every character being transmitted. The
longer the delay time is, the slower the transmission speed will be.
Inter-Character
Delay… (*0~254)
1) Read the barcode above to specify the inter-character delay.
2) Read the “Decimal Value” barcode on page 251 for the desired inter-character delay
(millisecond).
3) Read the “Validate” barcode on the same page to complete this setting.
To Next Page
Loading...
Need help?
General
