169
Update
Users can configure the data output format in which the collected data will be output to
the host computer. Barcodes read by the scanner will be processed in the following
sequence –
1) Perform character substitution on the data scanned.
2) Add Code ID and Length Code to the front of the data:[Code ID][Length Code][Data]
3) Process the whole data in step 2 with user formats. Data is now divided into fields by
user specified rules. Refer to Chapter 6 Applying Formats for Data Editing.
4) Add Prefix Code and Suffix Code before transmission:[Prefix Code][Processed
Data][Suffix Code]
IN THIS CHAPTER
5.1 Letter Case .............................................................. 169
5.2 Character Substitution ............................................... 170
5.3 Prefix/Suffix Code ..................................................... 180
5.4 Code ID ................................................................... 181
5.5 Length Code ............................................................. 189
5.6 Multi-Barcode Editor .................................................. 194
5.7 Removal of Special Character ..................................... 200
Ошибка! Источник ссылки не найден.Ошибка! Закладка
не определена.
5.1 LETTER CASE
By default, the alphabets transmission is case-sensitive, meaning that the alphabets will
be transmitted according to their original case. Ignoring the original letter case, select
[Upper Case] to output data in upper case only; otherwise, select [Lower Case] to output
data in lower case only.
To Next Page
Loading...
Need help?
General
