20
Enter Setup
2564 Barcode Scanner User Guide
2D ONE-SCAN BARCODE
Users can also scan a single 2D barcode combining with a series of serial commands to
configure the scanner. For example, if you want to change the suffix character to ‘#’, you
will need to input the serial commands in sequence as follows (underlining the digits is to
make them more readable):
#@CipherLab101231109902109903109994
Give the first hexadecimal digit of 0x23
Give the second hexadecimal digit of 0x23 for taking ‘#’ as the suffix
The serial commands above can be combined to form a single 2D barcode:
2D One-Scan Setup Barcode for configuring suffix
To Next Page
Loading...
Need help?
General
