43
Update
Chapter 1 Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь отображаться.
1.10 ADDON SECURITY FOR UPC/EAN BARCODES
The scanner is capable of decoding a mix of UPC/EAN barcodes with or without addons.
The read redundancy (2~30 times; default is set to 2) allows changing the number of
times to decode a UPC/EAN barcode before transmission. The more redundancy selected,
the higher the reading security is, and thus, the slower the reading speed becomes. It
will have to compromise between reading security and decoding speed.
Note: UPC/EAN Addon 2 and Addon 5 must be enabled individually for this setting to
take effect.
Addon Security Level
(*2~30)
1) Read the barcode above to specify the read redundancy for UPC/EAN barcodes. (It is
set to 2 by default.)
2) Read the “Decimal Value” barcode on page 251. For example, read “1” and “2” for the
scanner to re-read the barcode for 12 times.
3) Read the “Validate” barcode on the same page to complete this setting.
1.11 AUTO-SENSE MODE
Auto-sense is only available when the scanner is working in Laser Mode. The scanner will
be expecting barcodes as long as it is seated in the Auto-sense stand. Whenever a
barcode is brought within range, the scanner will be able to decode it.
To stop this mode, just remove the scanner from the stand.
To Next Page
Loading...
Need help?
General
