11
Update
Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь отображаться.
ENTER CONFIGURATION MODE
For the scanner to enter the configuration mode, have it read the "Enter Setup" barcode
located at the bottom of almost every even page of this manual.
The scanner will respond with six beeps and its LED indicator will become flashing red
after reading the barcode.
For configuring scanner parameters, see “Read a Setup Barcode” below.
EXIT CONFIGURATION MODE
For the scanner to save settings and exit the configuration mode, have it read the
“Update” barcode located at the bottom of almost every odd page of this manual. To exit
the configuration mode without saving any changes, have the scanner read the “Abort”
barcode instead.
Just like reading the “Enter Setup” barcode, the scanner will respond with six beeps
and its LED indicator will become flashing red after reading the barcode. Wait for a
few seconds for the scanner to restart itself.
To Next Page
Loading...
Need help?
General
