CipherLab 2564 User Manual

181
Update
Chapter 5 Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь отображаться.
5.4 CODE ID
Up to two characters for Code ID can be configured for each symbology. To make the
Code ID configuration easier, the scanner provides five pre-defined Code ID sets that can
select one and make necessary changes on it.
 If “Keyboard Wedge” or “USB HID” is configured for interface, Key Type and Key
Status will then become applicable. Decide whether to apply Key Status when select
“Normal Key” for Key Type.
Key Type
Key Status
Scan Code
Only 1 scan code value is allowed.
N/A
Normal Key
Up to 2 character strings are allowed.
 Add Shift
 Add Left Ctrl
 Add Left Alt
 Add Right Ctrl
 Add Right Alt
Refer to Keyboard Wedge Table.
Note: "]C1" is the Code ID of GS1-128 (EAN-128) barcodes; "]e0" is the default Code ID
of GS1 DataBar (RSS) barcodes.

CipherLab 2564 Specifications

General

Brand	CipherLab
Model	2564
Category	Barcode Reader
Language	English