200
Enter Setup
2564 Barcode Scanner User Guide
5.7 REMOVAL OF SPECIAL CHARACTER
Specify only 1 character, but it will remove every matching character encountered from
the starting position of barcode data until a different character is met. For example, if it
is configured to remove the character “0” (hex value is “30”), one or more zeros will be
stripped off the barcode data “012345” and “00012345”. However, for barcode data
“010333”, only the first zero will be stripped off.
1) Read the barcode above to remove the specified character.
2) Read the “Hexadecimal Value” barcode on page 252 for the desired character string.
For example, read “3” and “0” for the scanner to remove the character “0”.
3) Read the “Validate” barcode to complete this setting.
To Next Page
Loading...
Need help?
General
