80
Enter Setup
2564 Barcode Scanner User Guide
2.5.6 FLOW CONTROL
By default, there is no flow control in use. Select the flow control (handshake) method.
The scanner will activate the RTS signal upon powering on. After each good
read, the scanner will then wait for the CTS signal to become active. Data
will not be sent until the CTS signal becomes active.
The RTS signal will be activated after each good read. The scanner will
then wait for the CTS signal to become active. Data will not be sent until
the CTS signal becomes active.
It works the same as the Data Ready flow control except that the RTS
signal level is inverted.
To Next Page
Loading...
Need help?
General
