To Next Page

To Previous Page

Update

Chapter 1 Ошибка! Используйте вкладку "Главная" для применения Heading 1 к тексту, который должен здесь отображаться.

Note: Power-Saving won’t take effect when one of the following conditions is met:

(1) the scanner has already established a BT HID/SPP connection,

(2) the scanner is in the configuration mode,

(3) the setting value of Power-Saving is greater than that of Auto Power Off.

1.1.2.2 AUTO POWER OFF

For the scanner to save power, further to setting up “Power-Saving” mode, you may also

need to enable “Auto Power Off”, which deals with a time for the scanner to automatically

power off after power-on. Make the configuration that best suits your application while

noting the following points:

 Auto Power Off: 1~254 minutes configurable. 0= Disable.

1. By default, the scanner automatically shuts down 10 minutes after power-on.

2. If Auto Power Off isn’t desired, set the parameter to 0 to disable it.

Auto Power Off after

0~254 min. (*10)

1) Read the barcode above to enable the scanner to automatically turn off at a specified

time after power-on.

2) Assign the auto power off time by reading the “Decimal Value” barcode on page 251.

For example, read “1” and “5” for the scanner to automatically turn off after idleness

of 15 minutes.

3) Read the “Validate” barcode on the same page to complete this setting.

Note: “Auto Power Off” will not take effect when the scanner is in the configuration

mode.

CipherLab 2564 User Manual

Questions and Answers: