Cisco 2100 Series Configuration Guide

4-87
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring and Viewing Location Settings
RFID Tag
RSSI expiry timeout: 5 sec
Half life: 0 sec
Notify Threshold: 0 db
2. To see the location-based RFID statistics, enter this command:
show location statistics rfid
Information similar to the following appears:
RFID Statistics
Database Full : 0 Failed Delete: 0
Null Bufhandle: 0 Bad Packet: 0
Bad LWAPP Data: 0 Bad LWAPP Encap: 0
Off Channel: 0 Bad CCX Version: 0
Bad AP Info : 0
Above Max RSSI: 0 Below Max RSSI: 0
Invalid RSSI: 0 Add RSSI Failed: 0
Oldest Expired RSSI: 0 Smallest Overwrite: 0
3. To clear the location-based RFID statistics, enter this command:
clear location statistics rfid
4. To clear a specific RFID tag or all of the RFID tags in the entire database, enter this command:
clear location rfid {mac_address | all}
5. To see whether location presence (S69) is supported on a client, enter this command:
show client detail client_mac
When location presence is supported by a client and enabled on a location appliance, the location
appliance can provide the client with its location upon request. Location presence is enabled
automatically on CCXv5 clients.
Information similar to the following appears:
Client MAC Address............................... 00:40:96:b2:a3:44
Client Username ................................. N/A
AP MAC Address................................... 00:18:74:c7:c0:90
Client State..................................... Associated
Wireless LAN Id.................................. 1
BSSID............................................ 00:18:74:c7:c0:9f
Channel.......................................... 56
IP Address....................................... 192.168.10.28
Association Id................................... 1
Authentication Algorithm......................... Open System
Reason Code...................................... 0
Status Code...................................... 0
Session Timeout.................................. 0
Client CCX version............................... 5
Client E2E version............................... No E2E support
Diagnostics Capability........................... Supported
S69 Capability................................... Supported
Mirroring........................................ Disabled
QoS Level........................................ Silver
...
Note See the Cisco Wireless Control System Configuration Guide or the Cisco Location Appliance
Configuration Guide for instructions on enabling location presence on a location appliance.

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)