4-88
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring and Viewing Location Settings
6. To see the status of active Network Mobility Services Protocol (NMSP) connections, enter this
command:
show nmsp status
Information similar to the following appears:
LocServer IP TxEchoResp RxEchoReq TxData RxData
-------------- ----------- --------- ------- -------
171.71.132.158 21642 21642 51278 21253
7. To see the NMSP counters, enter this command:
show nmsp statistics {summary | connection all}
where
–
summary shows the common NMSP counters, and
–
connection all shows the connection-specific NMSP counters.
Information similar to the following appears for the show nmsp statistics summary command:
NMSP Global Counters
Client Measure Send Fail: 0
Send RSSI with no entry: 0
Send too big msg: 0
Failed SSL write: 0
Partial SSL write: 0
SSL write attempts to want write:
Transmit Q full: 0
Max Measure Notify Msg: 0
Max Info Notify Msg: 0
Max Tx Q Size: 2
Max Rx Size: 1
Max Info Notify Q Size: 0
Max Client Info Notify Delay: 0
Max Rogue AP Info Notify Delay: 0
Max Rogue Client Info Notify Delay: 0
Max Client Measure Notify Delay: 0
Max Tag Measure Notify Delay: 0
Max Rogue AP Measure Notify Delay: 0
Max Rogue Client Measure Notify Delay:0
Max Client Stats Notify Delay: 0
Max Tag Stats Notify Delay: 0
RFID Measurement Periodic: 0
RFID Measurement Immediate: 0
Reconnect Before Conn Timeout: 0
Information similar to the following appears for each active connection when you enter the show
nmsp statistics connection all command:
NMSP Connection Counters
Connection 1:
Connection status: UP
Freed Connection: 0
Nmsp Subscr Req: 0 NMSP Subscr Resp: 0
Info Req: 1 Info Resp: 1
Measure Req: 2 Measure Resp: 2
Stats Req: 2 Stats Resp: 2
Info Notify: 0 Measure Notify: 0
Loc Capability: 2
Location Req: 0 Location Rsp: 0
To Next Page
Loading...
Need help?
General
