Cisco 2100 Series Configuration Guide

5-62
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Configuring and Applying Access Control Lists
Figure 5-35 WLANs > Edit (Advanced) Page
Step 4
From the Override Interface ACL drop-down box, choose the ACL that you want to apply to this WLAN.
The ACL that you choose overrides any ACL that is configured for the interface. None is the default
value.
Note See Chapter 6 for more information on configuring WLANs.
Step 5 Click Apply to commit your changes.
Step 6 Click Save Configuration to save your changes.
Applying a Preauthentication Access Control List to a WLAN
Follow these steps to apply a preauthentication ACL to a WLAN using the controller GUI.
Step 1 Click WLANs to open the WLANs page.
Step 2 Click the ID number of the desired WLAN to open the WLANs > Edit page.
Step 3 Click the Security and Layer 3 tabs to open the WLANs > Edit (Security > Layer 3) page (see
Figure 5-36).
Figure 5-36 WLANs > Edit (Security > Layer 3) Page

Cisco 2100 Series Specifications

General

Power over Ethernet (PoE)	No
Form Factor	Desktop
Encryption	AES, TKIP
Maximum Access Points	6
Security	WPA, WPA2, 802.1X
Dimensions	1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)