5-89
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Managing Rogue Devices
Note WCS refers to this option as “Open Authentication.”
• Managed SSID—Requires that the rogue access point’s managed SSID (the SSID configured
for the WLAN) be known to the controller. No further configuration is required for this option.
Note The SSID and Managed SSID conditions cannot be used with the Match All operation
as these two SSID lists are mutually exclusive. If you define a rule with Match All and
have these two conditions configured, the rogue access points are never classified as
friendly or malicious because one of the conditions can never be met.
You can add up to six conditions per rule. When you add a condition, it appears under the Conditions
section (see Figure 5-44).
Figure 5-44 Rogue Rule > Edit Page
Note If you ever want to delete a condition from this rule, hover your cursor over the blue
drop-down arrow for that condition and click Remove.
f. Click Apply to commit your changes.
Step 4 Click Save Configuration to save your changes.
Step 5 If you want to change the order in which rogue classification rules are applied, follow these steps:
a. Click Back to return to the Rogue Rules page.
b. Click Change Priority to access the Rogue Rules > Priority page (see Figure 5-45).
To Next Page
Loading...
Need help?
General
