EasyManuals Logo

Cisco 2100 Series Configuration Guide

Cisco 2100 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #298 background imageLoading...
Page #298 background image
5-110
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Configuring IDS
Using the GUI to Upload or Download IDS Signatures
Follow these steps to upload or download IDS signatures using the controller GUI.
Step 1 If desired, create your own custom signature file.
Step 2 Make sure that you have a Trivial File Transfer Protocol (TFTP) server available. Keep these guidelines
in mind when setting up a TFTP server:
• If you are downloading through the service port, the TFTP server must be on the same subnet as the
service port because the service port is not routable, or you must create static routes on the
controller.
• If you are downloading through the distribution system network port, the TFTP server can be on the
same or a different subnet because the distribution system port is routable.
• A third-party TFTP server cannot run on the same computer as the Cisco WCS because the WCS
built-in TFTP server and the third-party TFTP server require the same communication port.
Step 3 If you are downloading a custom signature file (*.sig), copy it to the default directory on your TFTP
server.
Step 4 Click Commands to open the Download File to Controller page (see Figure 5-57).
Figure 5-57 Download File to Controller Page
Step 5
Perform one of the following:
• If you want to download a custom signature file to the controller, choose Signature File from the
File Type drop-down box on the Download File to Controller page.
• If you want to upload a standard signature file from the controller, click Upload File and then
choose Signature File from the File Type drop-down box on the Upload File from Controller page.
Step 6 From the Transfer Mode drop-down box, choose TFTP or FTP.
Step 7 In the IP Address field, enter the IP address of the TFTP or FTP server.
Step 8 If you are downloading the signature file using a TFTP server, enter the maximum number of times the
controller should attempt to download the signature file in the Maximum Retries field.
Range: 1 to 254
Default: 10

Table of Contents

Other manuals for Cisco 2100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2100 Series and is the answer not in the manual?

Cisco 2100 Series Specifications

General IconGeneral
Power over Ethernet (PoE)No
Form FactorDesktop
EncryptionAES, TKIP
Maximum Access Points6
SecurityWPA, WPA2, 802.1X
Dimensions1.75 x 8.0 x 8.5 in. (4.4 x 20.3 x 21.6 cm)

Related product manuals