6-4
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Figure 6-1 WLANs Page
This page lists all of the WLANs currently configured on the controller. For each WLAN, you can see
its WLAN ID, profile name, type, SSID, status, and security policies.
The total number of WLANs appears in the upper right-hand corner of the page. If the list of WLANs
spans multiple pages, you can access these pages by clicking the page number links.
Note If you want to delete a WLAN, hover your cursor over the blue drop-down arrow for that WLAN
and choose Remove, or check the check box to the left of the WLAN, choose Remove Selected
from the drop-down box, and click Go. A message appears asking you to confirm your decision.
If you proceed, the WLAN is removed from any access point group to which it is assigned and
from the access point’s radio.
Step 2 To create a new WLAN, choose Create New from the drop-down box and click Go. The WLANs > New
page appears (see Figure 6-2).
Figure 6-2 WLANs > New Page
Step 3
From the Type drop-down box, choose WLAN to create a WLAN.
Note If you want to create a guest LAN for wired guest users, choose Guest LAN and follow the
instructions in the “Configuring Wired Guest Access” section on page 10-23.
To Next Page
Loading...
Need help?
General
